Select from RIGHT SIDE EJECTION or LEFT SIDE EJECTION. The simple replacement of the upgraded PercivalĪrmaments Shell Deflector can help alleviate the issues, through an angled Shell deflector, and potentially hit the operator in the face or body (if Through the Tavor SAR or X95 can cause the ejecting case to skip past the factory To the tactical shooting experience of the Tavor SAR and X95 with the redesign ofįor the 5.56 models. Percival Armaments - Tavor SAR Dust Protection Plate Percival Armaments - Tavor and X-95 Shell Deflector - angled face for the 9mm Percival Armaments - Tavor and X-95 Shell Deflector - Angled and Contoured We can remove the hi-cap mag, if required by your state (put a note in the comments section when checking out.) ** Know your local laws! Certain items in the kit are restricted in some areas. 5.56 NATO conversion kit with a Cold Hammer Forged 16.5' barrel**, 1:7 twist, CrMoV steel. Includes all the parts needed for the conversion, 5.56 barrel, bolt/bolt-carrier, ejection port frame & shell deflector, one 30 round magazine**, and a barrel lock wrench. IWI TAVOR SAR Conversion Kit converts an existing 9mm rifle into a 5.56. * Bolts are not available individually without purchasing a barrel set, or sending your Tavor to us for the install. I’ve never had a problem with that part but I’ve read about people breaking that by torqueing that to hell without raising it.** IWI-US requires the Tavor barrel and new bolt to be headspaced by an IWI certified gun-smith/armorer ** PS When unlocking make sure you are pressing down on the little spring loaded piece that locks the lock in place so it can’t move on it’s own. One of these days I should do a thread on that with pics to help prevent others from doing the same thing. Straightened out the rod then figured out that when it bent it crushed the gas tube slightly so I replaced both those parts. My dumbass went 11b on it just torqued through it a few times couldn’t figure out why the barrel wouldn’t come out on the unlocked position then realized I bent the crap out of the charging handle assembly and the lock had eaten 3 I think half circle bites out of the soft aluminum charging handle assembly rod. Just make sure if it is hard to move on unlock double check that you removed the charging handle. Make sure it’s seated all the way first obviously. View QuoteI don’t remember it being too bad, it’s basically just two half circles, in locked they go in each other unlocked it’s a flat that doesn’t engage if I recall correctly.

Tavor barrel wrench alternative